TFU shadow guard build start

[lockey]

Ok going to need some help I am working with my team to make some shadow guards with 3d printers and wanted some advice.i have noticed that the weapons we are useing are a little different to some others are useing would this be a problem for approval. Also any suggestions for cutting programs or any way to make printing my Armour easier. All help appreciated

Sent from my SM-G935F using Tapatalk

[Batsk]

Good news on that front. The saberpike is not required for approval. When you take your submission photos you just need to be in costume. No props/weapons needed unless specified as required in the CRL.