TFU Royal Guard WIP from TR-20610

[rasagal]

Hi all, i am already approved as RotJ Guard

starting for a TFU Guard

Armor kit: Hero-Tec X (ordered)

Helmet: Fenix Props (from RotJ Guard)

Flightsuit: Dickies Redhawk WD4819

Gloves: from my Tie-Pilot or my Navy Trooper (must look whats fit better)

Boots: Decatlon Horse Rider Boots
Kama: self-made
Saber pike: 3D print
Belt: Klaus Frästüberl

Today just start with the Karma



Was the first try

i think i have to sharp up the trapazoid effect

[Allan1313]

The kama should try and follow the outside of the leg. Like if you look at a pair of jeans and see the seam line going straight down.

Nice start. Good luck!

Sent from my Pixel 5 using Tapatalk

[rasagal]

The kama should try and follow the outside of the leg. Like if you look at a pair of jeans and see the seam line going straight down.

Nice start. Good luck!

thx

yes, i shorten it round about 5-10 cm each side

[rasagal]

First try of Saber Pike is ready


And yes...its to long

[Maxall]

I don't think there's a hard and fast rule. I made mine so that the top of the emitter was at eye level. That seemed to make it managable.

[rasagal]

First steps with the armor and new Kama

[rasagal]

Shines Test

[rasagal]

[rasagal]

First fit try

[Allan1313]

Looks pretty good, nice job!

Sent from my Pixel 5 using Tapatalk