Helmet protection

Post by **Force Crush** » Thu Apr 13, 2017 8:53 pm

Hi everyone!
I was wondering if there's a way to protect the inside of the helmet so it doesn't scratch the surface of the breastplate and backplate of my armor.
What kind of material and glue can I use?
Thanks!

Post by **LuciousTalvloinne** » Fri Apr 14, 2017 4:53 am

You could use felt on the underside as that would be a soft surface so it doesn't affect the paint of the other parts.

Post by **Force Crush** » Fri Apr 14, 2017 4:55 am

Any glue in particular?

Post by **LuciousTalvloinne** » Fri Apr 14, 2017 6:08 am

e6000 is good cause you can move it to where you want before it sets.

Post by **Force Crush** » Fri Apr 14, 2017 1:30 pm

Thanks for the advice!

Post by **Force Crush** » Sat Apr 15, 2017 2:22 am

So, this is basically what happened to the end of my helmet. The photo with two red circles is the front and the photo with one red circle is the back of the helmet.

Post by **LuciousTalvloinne** » Sat Apr 15, 2017 5:34 am

Thats going to happen to the best of folks with trooping. Every so often I have to give my helmet a touch up.

Post by **Force Crush** » Sat Apr 15, 2017 12:55 pm

What can I use to touch up my helmet once in a while?

Post by **LuciousTalvloinne** » Sun Apr 16, 2017 9:24 am

you could use a light brush with paint to dab any minor scratches of the paint wear.

Post by **Force Crush** » Mon Apr 17, 2017 4:19 am

Many thanks again for the advice!

Helmet protection

As seen in the video game "The Force Unleashed". Now an approved costume!

Helmet protection

Re: Helmet protection

Re: Helmet protection

Re: Helmet protection

Re: Helmet protection

Re: Helmet protection

Re: Helmet protection

Re: Helmet protection

Re: Helmet protection

Re: Helmet protection