New Shadow Guars - Leicester WIP

[Sascha_Wilsing]

This is comming out very nicely. Looks good. Thanks for the WIP.

[Chris smith]

well not been on hear for a while I know but quick update I have startd work on my Force Pick using bits from an old Vader Lightsabre.

[Chris smith]

I folks work continues on the force pick thought I would drop in a few new photos.







Top section is 3d printed while the centre is 28mm Ali tube with nylon turned grips. Only one show but there will be two and then all sprayed black more to follow.

[Chris smith]

Further Update Helmet sprayed and all done one more off the list getting closer to submittal I hope.





Very happy don't do spraying usually

[Chris smith]

Ok Abb Plate Started using Pepakura files as a base but fabricating. I am Using 1.5mm ABS. I plan to over skin this with fibreglass tissue. Then Spray Black.

[Sascha_Wilsing]

I hope the shoulder parts of your chest and back armour are still covered by the helmet.

[Chris smith]

So od I as the helmet cost a pretty penny.......

[Chris smith]

Hi folks just some photos from the last week for info and update.........























Been busy and more busy to come strapping the armour up.