Shoulder Bells

[TR2203]

Hi All,

I'm after some help/guidance/advice on the Shadow Guard shoulder bells. I've just taken delivery of a set of bells which I need to cut to the necessary shape.







The section I plan to cut is 30mm wide and 80mm (inside) and 100mm (outside). The bells are a total of 210mm wide. Would this be acceptable or should it be more or less?

As said help/guidance/advice would be appreciated as I don't want to cut away too much!

Thanks in advance.

Ian

[virateck]

for me this is good

[stripes]

It's hard to say without a reference as to how they will be sitting on your shoulders.... you may need to cut more or less, but I don't want to advise you without seeing where they potentially sit in the first place.

[kivas]

Agreed

[TR2203]

It's hard to say without a reference as to how they will be sitting on your shoulders.... you may need to cut more or less, but I don't want to advise you without seeing where they potentially sit in the first place.

Thanks - its appreciated!

Hope these help? -

[LuciousTalvloinne]

Proceed with the operational cutting.