Home of the Sovereign Protectors

Hi All, I've finally actually sat down took some pics - not that great - over flash -

I'll give the run down of what I did -

Helmet - typical fiberglass Royal guard helmet - shoulders trimmed back for the more tapered
v look is a must
- sand, paint, sand, paint - you get the idea - double layer of red window tint used for the visor.

Chest & back - TK front - custom made back from a tk

Shoulder bells - TK - cut in half raised section removed, re-assembled and made seamless... then trimmed to measure - the template Lucious talks about helped - but again you'll need to scale it to you.

Ab plate - again custom made - sintra - made to my scale - note the hole - that's for the buckle to go into - keeps thing tight.

Gauntlets - custom made from scratch out of sintra, measured my forarms - had a rough idea and went at it - they must have the ...I'll call it sweep at the front and the back - I think you know what I mean

Belt - standard Tandy Blank, so was the buckle itself - Grooved the belt using a jig made for a table saw - worked great - Center piece - simple made to scale out of wood

Shins - ala Jango style - but symentrical - again custom made from sintra and scaled to me.

Its ok Kivas we can work with over flash and tone the lighting down. I was curious on the belt and ab plate. I plan on finishing up this costume on my vacation in May. Link pics when you are ready

- sorry all - putting this in a couple posts as something weird was going on and couldn't see what I was writing.

Boots - standard officer boots - zipper on inside only
Metatarsal plates - custom made out of sintra - there is a sweep to the leading edge - attached with strap underneath.

Jumpsuit - custom made by a friend - note the velcro placements for the belt as well as the ab plate - the Kama is attached.

- The crown jewel -
Saber pike
- all custom made by me - started with a pole from home depot - cut it down to what I wanted.
- I then scaled the rings for this and custom made each seperate one out of various wood as each one is a slightly different size -
- angle bits - custom made to fit out of sintra
- square bits on the top ring were from and old Jango Jet pack
- wiring - obvious - electrical wire tightly wrapped and ca'd in place.
- saber iteself - FX - disassembled and re-wired to have the power/sound at the bottom of the pike - gives great balance
- note one of the photos at the top you can see where I hide the on/off switch.

looks like will be three posts

um.. ok an idea why only half the photos are showing up

I'll get with Ang on that. could be done with a simple image sizing code.

Probably as I seem to think we are having that same issue on our Garrision board.

Excellent work buddy!!!

How did u manage to cut the ridge of the fiberglass helmet without it cracking? Im a little scared to do it to mine incase i screw it up completely.

I see u went for the Sintra for the forearms/ab plate etc like myself. How strong is it do ya know?? I only ask as ive never used it before and its actually another member of my club that is building the armour parts for me.

Any chance of some pics of the strapping system u used on it all???

Looking good Kivas!!!

For cutting the Helmet - I marked the lines then grabbed my dremel & eye protection and had at it... no guts no glory

Sintra - can take alot of abuse - only complaint it it's white so when damage occurs white shows.

Strapping system is very simple on the shoulders - knee pads in the shoulder bells for the right height and then has a strap around the underside.
Chest & back are also strapped together with parachute clips - considering they don't show so comfort cam 1st - and also can be easily adjusted when needed.