Page 1 of 2
TFU Royal Guard WIP from TR-20610
Posted: Sat Jan 23, 2021 9:06 pm
by rasagal
Hi all, i am already approved as RotJ Guard
starting for a TFU Guard
Armor kit: Hero-Tec X (ordered)
Helmet: Fenix Props (from RotJ Guard)
Flightsuit: Dickies Redhawk WD4819
Gloves: from my Tie-Pilot or my Navy Trooper (must look whats fit better)
Boots: Decatlon Horse Rider Boots
Kama: self-made
Saber pike: 3D print
Belt: Klaus Frästüberl
Today just start with the Karma
Was the first try
i think i have to sharp up the trapazoid effect
Re: TFU Royal Guard WIP from TR-20610
Posted: Sat Jan 23, 2021 9:12 pm
by Allan1313
The kama should try and follow the outside of the leg. Like if you look at a pair of jeans and see the seam line going straight down.
Nice start. Good luck!
Sent from my Pixel 5 using Tapatalk
Re: TFU Royal Guard WIP from TR-20610
Posted: Sat Jan 23, 2021 9:15 pm
by rasagal
Allan1313 wrote: ↑Sat Jan 23, 2021 9:12 pm
The kama should try and follow the outside of the leg. Like if you look at a pair of jeans and see the seam line going straight down.
Nice start. Good luck!
thx
yes, i shorten it round about 5-10 cm each side
Re: TFU Royal Guard WIP from TR-20610
Posted: Sun Jan 24, 2021 6:32 pm
by rasagal
Re: TFU Royal Guard WIP from TR-20610
Posted: Mon Jan 25, 2021 2:49 am
by Maxall
I don't think there's a hard and fast rule. I made mine so that the top of the emitter was at eye level. That seemed to make it managable.
Re: TFU Royal Guard WIP from TR-20610
Posted: Fri Jan 29, 2021 7:51 pm
by rasagal
Re: TFU Royal Guard WIP from TR-20610
Posted: Sat Jan 30, 2021 10:43 am
by rasagal
Re: TFU Royal Guard WIP from TR-20610
Posted: Sat Jan 30, 2021 12:28 pm
by rasagal
Re: TFU Royal Guard WIP from TR-20610
Posted: Thu Feb 25, 2021 3:25 pm
by rasagal
Re: TFU Royal Guard WIP from TR-20610
Posted: Thu Feb 25, 2021 3:39 pm
by Allan1313
Looks pretty good, nice job!
Sent from my Pixel 5 using Tapatalk