Home of the Sovereign Protectors

I’m working on my build right now and have two helmets from two different vendors. Both are very nice, but due to the shape of the helmet, I can see where it could be hard to wear for extended periods of time or easy to hyperventilate in. What are people doing to make the experience more tolerable?

I bought two of these and attached hoses to them that go up to the helmet.



Works great !

https://www.amazon.com/dp/B0719JNFF7/?c ... _lig_dp_it

Here's my post on it in my build thread !

dwdj75 wrote: ↑Sat May 06, 2017 5:07 pm Started working on the cooling units.

Purchased two mini hand held coolers and began fabricating them to fit on a back brace.




Covered the vents and attached a 1/2 in connector ...

That’s amazing! Do you have pics of the finished setup?

I take my helmet off after a while, just remember to breathe slowly and you’ll be fine.

Ralom wrote: ↑Tue Jan 26, 2021 12:42 am That’s amazing! Do you have pics of the finished setup?

I don't but I sure can when I get home !

I will say, that I was not a fan of the hoses in the pics, I changed them to a clear firmer hose.