Page 1 of 2
					
				Bucket Cooling
				Posted: Mon Jan 28, 2019 10:34 pm
				by Maxall
				Has anyone looked at Troopacoola for a cooling option for their bucket? He's got a two piece setup for Snow Troopers that looks like it would be promising. One piece fits in the chest and blows clear air into the bucket. the other part moves the air around.
Looks to be more expensive, but better contained that what I was thinking about jerry-rigging a pair of hand held coolers.
			 
			
					
				Re: Bucket Cooling
				Posted: Fri Feb 01, 2019 8:15 pm
				by Starwarsgeek18
				If I remember correctly he had asked for local guards in the UK to test a potential guard system, I'm not going to confirm or deny anything, that's all I saw.
			 
			
					
				Re: Bucket Cooling
				Posted: Sat Feb 16, 2019 10:19 pm
				by Allan1313
				I just use 3 of the little squirrel fans. Works reasonably well. Cost was very cheap too haha

 
			
					
				Re: Bucket Cooling
				Posted: Sat May 04, 2019 5:11 pm
				by Maxall
				Picket up a Snow Trooper Kit from Troopacoola. 
Going to run one set in my chest with hoses under my bucket. The other set in m bucket to keep everything moving around in there.

 
			
					
				Re: Bucket Cooling
				Posted: Sat Jul 27, 2019 7:53 pm
				by OCD_Chad
				Here is the one he made for me.  The two tubes are attached to two fans that pull in external air which are powered by an Anker PowerCore 10000.  The power supply in the helmet is also an Anker PowerCore 10000.
 

 
			
					
				Re: Bucket Cooling
				Posted: Sat Jul 27, 2019 9:31 pm
				by Maxall
				OCD_Chad, that looks like what I'm going to end up doing with mine. How do you like it? Any changes you'd make?
			 
			
					
				Re: Bucket Cooling
				Posted: Sun Jul 28, 2019 6:13 am
				by OCD_Chad
				Maxall wrote:OCD_Chad, that looks like what I'm going to end up doing with mine. How do you like it? Any changes you'd make?
I like it, those two tubes make a noticeable difference in the temperature of the air I'm breathing.  No.
 
			
					
				Re: Bucket Cooling
				Posted: Sat Oct 05, 2019 1:58 am
				by aislefive
				OCD_Chad wrote:Here is the one he made for me.  The two tubes are attached to two fans that pull in external air which are powered by an Anker PowerCore 10000.  The power supply in the helmet is also an Anker PowerCore 10000.
 

 
Any chance could you show a picture of your fans and hose hookup?
 
			
					
				Re: Bucket Cooling
				Posted: Sat Oct 12, 2019 7:26 pm
				by OCD_Chad
				aislefive wrote:OCD_Chad wrote:Here is the one he made for me.  The two tubes are attached to two fans that pull in external air which are powered by an Anker PowerCore 10000.  The power supply in the helmet is also an Anker PowerCore 10000.
 

 
Any chance could you show a picture of your fans and hose hookup?
 
I used some velcro sticky back fabric tape to put them on these shorts.  The switch and power supply are in the pocket.  The tubes go under the inner robe.

 
			
					
				Re: Bucket Cooling
				Posted: Thu Mar 26, 2020 6:49 am
				by robertjohn2
				Troopacoola with 2 or more fans works well. This advice with the Snow Trooper Kit is helpful.