Home of the Sovereign Protectors

G'day all I am getting to the part of my build that I need community assistance. I feel that my
underclothes meet the standards for info it is sitting 2 inches from the floor. I need some input
on my robes before I make an alteration that I cant undo. I will post the Outer robe pictures
tomorrow.

Untitled by Scott Hughes, on Flickr

I think It looks ok but I really want your opinions in addition it has been mentioned about adding a slit
in the Thawb but I can not see the pictures of previous posts due to photo bucket being used.

Hard to see in this picture, is the smailer sash on top of the larger sash? Length loosk to be fine to allow for walking.

Cheers mate it’s the same, did not release it blends in so well.

Looking pretty good so far

Nice build!

Untitled by Scott Hughes, on Flickr


Ok ignore the length of the robe I am going to leave that to last, I am interested in feed back on how the robe sits and its
size I had minimal concerns about how much pleats(Not sure if its the right word are in the front compared to the CRL Picture but the movie one is similar to mine.

Untitled by Scott Hughes, on Flickr

Last Picture is where my arm sits the current gap sits about level with my elbow should it is further up my arm a further 6 inches or so ?

Untitled by Scott Hughes, on Flickr

Untitled by Scott Hughes, on Flickr

Untitled by Scott Hughes, on Flickr

Size and look are very good.
Maybe a little bit shorter.
You can go up with the slit a bit. Max 10cm i would say.

Thanks mate I will alter the arm slit by 10cm and hem the bottom to an inch off the ground and then I am done. Cheers and Beers for the assistance.

Untitled by Scott Hughes, on Flickr

Mynock wrote:Untitled by Scott Hughes, on Flickr

The only other suggestion I could make is having your helmet better match the colour of your cloak