Home of the Sovereign Protectors

For creative folks who want to try turning their own on a lathe or creating a 3D Print file, I got around to making up some reference drawings of my second translation of the schematic. I scaled the size to work when slid over 1"ID electrical PVC Conduit pipe that can be found at most major hardware stores.

If they're useful to anyone, enjoy.









I referenced the 533x691 resolution image from here. If anyone has a higher resolution or sharper image than that, pass it along or point me to it and I'll be happy to update these. I'm going to take a third pass at translating to a clearer schematic with an eye toward the lines not necessarily being so ... linear you might say, however this will be referencing that same image so a vauge shadows set of pixels will still have a bit of variation where the hardline can fall.

Awesome - these are really helpful, one request... A higher resolution version of image 1 would be great if you could please - I can't make out the dimensions even when zooming in!

whiteee wrote:Awesome - these are really helpful, one request... A higher resolution version of image 1 would be great if you could please - I can't make out the dimensions even when zooming in!

Ah, sorry about that. Give the following links a try. This is the largest resolution I have printed them in without being scaled down by hosting sites.

High Res 1 of 4

High Res 2 of 4

High Res 3 of 4

High Res 4 of 4

How long is the staff supposed to be?

1.83 meters being standard height or 6 foot. The top of the emitter rest at eye level on my tfu guard.

LuciousTalvloinne wrote:1.83 meters being standard height or 6 foot. The top of the emitter rest at eye level on my tfu guard.

so is to best to cut them so the top of the pike is eye level as the one i seen have be neck height
and guessing you cut them to suit the size of the trooper ?

Pretty much, it's like the forcepike ratio theory. Scale to the troopers comfort aspect. A tall trooper would have a full size pike while a shorter trooper would have one scaled down.

LuciousTalvloinne wrote:Pretty much, it's like the forcepike ratio theory. Scale to the troopers comfort aspect. A tall trooper would have a full size pike while a shorter trooper would have one scaled down.

thanks good to know as now have 2 kits to build and my mate is small then me