Page 1 of 4
WIP Royal Guard AOTC from Austria :)
Posted: Thu May 26, 2016 7:57 pm
by Charon
Hi !!!
I was starting my Royal Guard AOTC and now I want to know, are these boots ok ? I have seen it on ebay and the shop is in germany next to austria were i´am from.

Re: WIP Royal Guard AOTC from Austria :)
Posted: Thu May 26, 2016 9:41 pm
by Skoom
Hello and welcome.
I would say these boots are fine.
Re: WIP Royal Guard AOTC from Austria :)
Posted: Thu May 26, 2016 10:12 pm
by Sascha_Wilsing
Welcome.
Yes. Boots are fine.
Re: WIP Royal Guard AOTC from Austria :)
Posted: Sat May 28, 2016 7:43 pm
by Charon
Thanks for the feedback. Boots are still ordered

Re: WIP Royal Guard AOTC from Austria :)
Posted: Tue Jun 07, 2016 7:43 pm
by Charon
Today I got my Force Pike from Dirk (Cabbagefarmer). He made it realy quickly and the shipping was unbelivable fast

. It´s realy a very nice Force Pike, thank you. The next part is the inner and outer robe. If I have the first pictures, I will post it here to get your opinion. The bucket is also orderd from Kamino Custom, but I will get it not before october. So I have enough time for the robes.Thanks everybody for the support

.

Re: WIP Royal Guard AOTC from Austria :)
Posted: Wed Jun 08, 2016 5:30 pm
by JC27
That is a nice force pike, do you have info on how you got it?
Re: WIP Royal Guard AOTC from Austria :)
Posted: Wed Jun 08, 2016 6:33 pm
by Sascha_Wilsing
There is a sell thread here in the forum from Cabbagefarmer.
Re: WIP Royal Guard AOTC from Austria :)
Posted: Fri Jun 17, 2016 3:44 pm
by Charon
Hi !!!
Does somebody have an detail foto from the part below the neck of the inner rob on the back side? My tailor asked me how does it work. Is there an zipper, velcro or anything else ? How far can the slit go down ? I couldn´t find any informations about this in the forum.
Thanks for the support

Re: WIP Royal Guard AOTC from Austria :)
Posted: Sat Jun 18, 2016 1:24 am
by cooldevo
Most seem to use a zipper, which is what I did.
Velcro I'd recommend being careful with as you don't want it to snag the velvet of either robe if your placement is off. If you have some sort of fabric "safe" velcro that may work better as it shouldn't snag, but can be hard to find in some areas of the world.
Re: WIP Royal Guard AOTC from Austria :)
Posted: Sun Jun 19, 2016 6:09 pm
by Charon
Thanks !!
Then I also take a zipper for back side of the inner robe.