Page 1 of 2

Reclaimer 57's Shadow Guard

Posted: Tue Aug 25, 2015 5:18 am
by Reclaimer57
Just recently got all my soft bits except my Kama. I'm waiting on my armor bits from a local seller.

I also included some shots of my boots that took a bit of a scuff. The fake leather rubbed off. Any ideas how I can cover that up or repair them?

Thoughts?


http://imgur.com/a/rQxw5

Re: Reclaimer 57's Shadow Guard

Posted: Tue Aug 25, 2015 5:41 am
by LuciousTalvloinne
Shoe Polish like you would do for Military boots.

Re: Reclaimer 57's Shadow Guard

Posted: Tue Aug 25, 2015 2:05 pm
by Sascha_Wilsing
Just black shoe polish.

Re: Reclaimer 57's Shadow Guard

Posted: Wed Aug 26, 2015 12:43 am
by Reclaimer57
Thankyou for the replies I'll get right on the shoe repairs.

Other than that what do you think of the costume so far?

Re: Reclaimer 57's Shadow Guard

Posted: Wed Aug 26, 2015 12:21 pm
by Sascha_Wilsing
:shadow:
Kama and Armor next, then finish the helmet. Do you have a pic where the split in the backpart of the robe can be seen?

Re: Reclaimer 57's Shadow Guard

Posted: Wed Aug 26, 2015 2:22 pm
by Reclaimer57
Yup, while taking the pictures I neglected to show how the back seperates but if you look close in the pictures of the back you'll see the vertical line where its open. Ill either retake a picture so you can all see it or just wait till certification pictures to show it.

Re: Reclaimer 57's Shadow Guard

Posted: Thu Oct 15, 2015 5:22 pm
by Reclaimer57
So I made a little mistake when working on my helmet. As I was removing the old shield under the visor to widen my view I was using a mix of a box cutter to slowly trim away and a pair of wire snips to take larger chunks out. While removing a chunk I had a crack spread in an instant over to the side of the helmet. It's a very flush crack. When not touched the crack reseals and deceptively disappears. My plan is to open the crack a little, fill it with something, push it closed then sand off the excess of whatever bonding agent I use. Now for those of you following along at home this is a Don Post helmet. What should I buy to seal the crack? Or is there another method I should be doing?

Pics in link

http://imgur.com/a/DwOln

Re: Reclaimer 57's Shadow Guard

Posted: Thu Oct 15, 2015 9:31 pm
by Jofus
I would add some fiberglass to the inside where it cracked to strengthen it and then put bondo on the outside and maybe even a little in the crack, then sand it flush and smooth once the bondo hardens. Now this is just an educated guess but it should work.

Re: Reclaimer 57's Shadow Guard

Posted: Wed Dec 23, 2015 9:21 am
by Reclaimer57
I have 2 new pictures. As these are commonly the two things I have seen being questioned here is my shoulder bell and boot setup. Both are dry fits.



http://imgur.com/a/aN93z

Re: Reclaimer 57's Shadow Guard

Posted: Wed Dec 23, 2015 7:11 pm
by Sascha_Wilsing
Shoulders are fine.
The spats need to go over the whole boot. From the ground over the boot to the ground.