Page 1 of 1
ABS helmet trimming question
Posted: Sat Jun 27, 2015 3:50 am
by Redgirl41
Hello All!
I would like to work on my helmet, but need to trim it. There is a return edge on the bottom, should I cut this off?
Re: ABS helmet trimming question
Posted: Sat Jun 27, 2015 7:30 am
by LuciousTalvloinne
Could you explain more of what your wanting to do so that we could further assist you. All guest helmets normally have a return edge.
Re: ABS helmet trimming question
Posted: Sat Jun 27, 2015 1:40 pm
by Sascha_Wilsing
A picture of what you want to trim would be good. Then we can help you easier.
Re: ABS helmet trimming question
Posted: Sun Jun 28, 2015 11:15 am
by DarkFather
Redgirl41 wrote:Hello All!
I would like to work on my helmet, but need to trim it. There is a return edge on the bottom, should I cut this off?
Hi Redgirl;
I contacted 'Q' about this same thing. He said (as with a TK bucket), build and bondo the TR bucket first, then once done, BEFORE painting, trim around the bottom. Leave a 5-8mm return edge all the way around.
Hope that helps.
Re: ABS helmet trimming question
Posted: Tue Jun 30, 2015 4:37 am
by Redgirl41
Thank you! That was very helpful.
