Robes WIP

[Library Guard]

Hi gang,

Here are some pics of my robes in progress. I haven't hemmed the inner robes yet, and was thinking about shortening the sleeve length a bit. The outer robes are obviously made from muslin. No hemming here either, and the right shoulder is only pinned in place in these pics. I am planning on securing that side with a clasp which will disappear under the fabric.

What do you all think?

[Sascha_Wilsing]

I would shorten the sleeves 0.5 to 1cm.
And the overall length of the inner and outer robe too.
Inner robe should be shorter then the outer.

[Gruff]

Agreed. Also make sure there is a split on the inner robe so that you can walk

[Library Guard]

Thanks, guys. That's what I was thinking length-wise. I'm waiting on boots and gloves (both this week, hopefully), before I make the alterations. I did NOT think about a slit in the inner robe. Good call.

Here's the outer robe. I will do the lining next, which should settle down and close up the arm slit.

[Library Guard]

A couple more tweaks and I think I'm ready for application pics. See anything that needs fixing?

[LuciousTalvloinne]

Actually Would like to see full 360 of the costume with outer robe and then with under robe.

[Library Guard]

Here you go:

[LuciousTalvloinne]

You should have no problem passing minimum requirements.

[Sascha_Wilsing]

I agree.
Please try to make photos were your outer robe is all the same height from the ground around you.
Someone putting the robe in the right Position should help.

[Library Guard]

Thank you all for the help...I'm approved!