Home of the Sovereign Protectors

Its in the AOTC/ROTS pike section. It'll be slightly different but for the most part its should be close. Heres a link to the thread

http://kaminobase.com/forcepike/forum/v ... ?f=28&t=13

Bookemdano wrote:I'm following Skel's tutorial and found a pole close to what he got. I was in Walmart the other day and just happened to see 1 Shakespere Durango pole and picked it up for $7.95. Only difference is the one I found is a 13' and is 4 section instead of 10' and 3 section.

Its light as can be, just need to get the part from Lowes. Only problem is that shipping is more than the part and the closest one is 4 hrs away

That's exactly what I did...and yea...the backflow part I found on amazon and shipping cost almost as much or more than the part >.<

Wicked good tutorial, man. I am now seriously torn between the two! Just bought a two-piece pool cue from wal-mart, and I have 4 different ski poles. Can't decide. maybe I'll make two...

Skel Had a good reference on the pike to go from So I had him tweek my old design and make me a new one Now to just get that "ON" switch to work

LuciousTalvloinne wrote:Skel Had a good reference on the pike to go from So I had him tweek my old design and make me a new one Now to just get that "ON" switch to work

I have considered getting one of those joke pens that shock you and intergrating it into the design...but that's a lot of work for a limited payout

JesterTDA wrote: I have considered getting one of those joke pens that shock you and intergrating it into the design...but that's a lot of work for a limited payout

I have too thought of this, and I don't think it would be too hard for either the ski pole or pool cue. All you would need to do is remove the actual tip and electonics from the pen and slide it into a slit carved out, then fill with 5 minute epoxy. Battery changing would be an issue though...

I'm going to say that "shocking pike" is not the best idea. What could seam like a cute joke could come into some serious allegations.

Thanks for the props on my Pike Tutorial. I know a number of people have had trouble finding the smaller size fishing pole that I used. You can use a larger pole...just be aware that I chose this smaller pole because almost all the other parts I used fit perfectly over it. If you upsize the pole...you may need to substitute larger parts for the everything else on the pike. This may work great for you...or it may cause you more work. Just a FYI.