Again, my allergy to specific measurements with this CRL strikes again, and I've consulted with other members of DCS and we feel that this is getting too specific- we don't expect GMLs and costumers to break out the calipers to measure 0.5-1mm.andyman97 wrote: ↑Wed Aug 02, 2023 1:41 pm If the intent is to use a single layer for a thicker material and a double layer for a thinner material, I'd suggest mentioning that. As it reads now, there is only a mention that Ultrasuede and single layer is required for level 2, which means that either/or both could apply to basic, especially considering there is still verbiage for basic about a raw edge.
I'd suggest something along the lines of:
-For material with an approximate thickness of 1 mm, a single layer of material with a raw edge will be used
-For material with an approximate thickness of .5mm or less, a double layer of material will be used
Having the CRL written this way allows for greater flexibility within the guidelines for L1, to allow for microsuede/ponte de roma/whatever fabric the costumer chooses to either be 1 or 2 layer, to get the right look. However, for L2 we know that ultrasuede was used as a single layer, so a double layer would be inaccurate, thus it would be restricted to a single layer.
In the end, the costumer and GML is free to consult with DCA/DCS to clarify, that's what we're here for.