Getting Screws out of Rubies Visor

[yourscout]

Getting screws out of the rubies helmet

Does anyone have a good way to get these screws out? No screwdriver is working, afraid to use pliers since they might scratch or damage the helmet, making it so I cant return it.

[iceknyght]

I just did this and ended up having to cut/break the visor. All the screws came out fine except the top one, which I ended up stripping... I then cut the visor out around that one screw and was able to get the screw out with some needle nose pliers...

So to answer you're question, no... LOL! But, definitely make sure the screwdriver you're using is small and fits the small screw top (not too big/small), cause I think having a slightly big screwdriver head on top of the screw being tightened tightly made stripping it super easy to do...

[Talmor]

Hope you got it out!

Mine came out back in the day with a small screwdriver and some light pressure (constant) the whole time. Screws were not in that deep.

In fact, I re-used 2 screws up top with my new lens and it kept the bottom 'open' to allow some nice COOL refreshing airflow in and seriously helped with the fogging up issue!

[RC130Niner]

As I just did this, I found that although the screws are Philips, the screwdriver that worked was a very small flat, which was the only one that would fit the very shallow top and provide enough torque to actually remove it.
And as others said, I just gapped the visor with some rubber washers and reused the same screws, it was fairly easy.