Shaft Question

Post Reply
Szycha
Posts: 1
Joined: Wed Dec 02, 2020 11:02 am

Shaft Question

Post by Szycha »

Hello,

I have a question regarding shaft diameter. I saw a lot of different projects of force pikes and the thing, that got my attention was quite huge variety of shaft diameters (from 16mm to 3-4 cm). Does the shaft diameter is important during registration and - most importantly - are the thiner (16mm) pikes accepted?

Regards,
Greg

User avatar
NitroSpartacus
Posts: 63
Joined: Thu Nov 16, 2017 7:45 pm
TKID: 82065
Location: Northeast Remnant

Re: Shaft Question

Post by NitroSpartacus »

All the pikes I've seen are tapered. So the bottom is much wider than the top. Like a billiards cue.

Post Reply