Looking good so far, if you need a hand hunting for stuff feel free to PM me.

If anyone could PM me or link me to an under robes pattern or stockpile of reference photos id be much appreciative.

Currently putting the vambraces together. Im simply using a shim on the inside to bridge the gap between the halves. Im using E6000 and a lot of clamps. After they are attatched ill bondo them and sand them to a seamless piece.
Pics below.
http://imgur.com/a/08WLj

That looks awesome!! Id love to pick your brain about your saber pike. It looks amazing.

Howdy all!! Heres my progress so far. I waited 3 days for the E6000 to cure and attatched elastic with snaps. Giving it a firm fit. They don't move at all when I walk. However when the E6000 cured it warped the plastic. So Ill have to spead on a little bondo. On to the spats!! http://imgur.com/a/TzGRk

pben wrote:Are jackboots approvable? Like these ones:

http://www.ebay.com/itm/WWII-German-EM- ... 1645250680

I think the Jackboots are not long enough and too wide at the top to work. Look more into riding boots and officer boots.

Sascha_Wilsing wrote:Shoulders are fine.
The spats need to go over the whole boot. From the ground over the boot to the ground.

Easy fix thanks for the input.

Absolutely any help I can offer. I bought it at an Army Navy surplus store. I tried some google searchs and found a few links. I have some pictures of the tag which should help. It had pockets all over it but they were super easy to remove. Best of luck!

http://imgur.com/a/eVRso

I have 2 new pictures. As these are commonly the two things I have seen being questioned here is my shoulder bell and boot setup. Both are dry fits.



http://imgur.com/a/aN93z

So I made a little mistake when working on my helmet. As I was removing the old shield under the visor to widen my view I was using a mix of a box cutter to slowly trim away and a pair of wire snips to take larger chunks out. While removing a chunk I had a crack spread in an instant over to the side...